Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2005 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 54 (Continuously Variable Transmission (CVT)) >> Service Information >> DTC P1701 Transmission Control Module (Power Supply) >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2009 Nissan Sentra. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If "DTC Confirmation Procedure" has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

After the repair, perform the following procedure to confirm the malfunction is eliminated.

WITH CONSULT-III 

  1. Turn ignition switch ON. (Do not start engine.)
  2. Select "DATA MONITOR" mode for "TRANSMISSION" with CONSULT-III.
  3. Wait for at least 2 consecutive seconds.
  4. If DTC is detected, go to "DIAGNOSIS PROCEDURE ".
scientia non olet · About Mike's Workshop Manuals