Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2005 >> Sentra SE-R >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - DTCS P1143 To P2138 (Qr25DE) >> DTC P2135: TP Sensor >> Diagnostic Trouble Codes Confirmation Procedure

Diagnostic Trouble Codes Confirmation Procedure

NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

TESTING CONDITION: 

Before performing the following procedure, confirm that battery voltage is more than 10V at idle. 

With CONSULT-II 

  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT-II.
    Fig 1: DATA MONITOR - CONSULT-II Display Screen
    G02454245Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Start engine and let it idle for 1 second.
  4. If DTC is detected, go to "DIAGNOSTIC PROCEDURE "

With GST 

Follow the procedure "WITH CONSULT-II" above.

scientia non olet · About Mike's Workshop Manuals