Consult-II Basic Operation Procedure (With Power Door Locks)

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carries out CAN communication.

With the ignition switch OFF, connect CONSULT-II and CONSULT-II CONVERTER to the data link connector, then turn ignition switch ON.

Fig 1: Identifying Data Link Connector
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "START (NISSAN BASED VHCL)".

Fig 2: Identifying "START (NISSAN BASED VHCL)"
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "SMART ENTRANCE".

Fig 3: Identifying Select System Screen
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "KEY WARN ALM", "LIGHT WARN ALM" or "SEAT BELT ALM".

Fig 4: Identifying "KEY WARN ALM", "LIGHT WARN ALM" And "SEAT BELT ALM"
Courtesy of NISSAN MOTOR CO., U.S.A.
Select diagnosis mode.
"DATA MONITOR" and "ACTIVE TEST" are available for the warning chime.

Fig 5: Identifying "DATA MONITOR" And "ACTIVE TEST"
Courtesy of NISSAN MOTOR CO., U.S.A.