Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2005 >> Quest Base >> Repair and Diagnosis >> Engine Performance >> Engine Control System >> DTC P0340, P0345: CMP Sensor (Phase) >> Component Inspection >> Camshaft Position Sensor (Phase)

Camshaft Position Sensor (Phase)

  1. Loosen the fixing bolt of the sensor.
  2. Disconnect camshaft position sensor (PHASE) harness connector.
  3. Remove the sensor.
  4. Visually check the sensor for chipping.
    Fig 1: Identifying Camshaft Position Sensor - Phase
    G02474029Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Check resistance as shown in the figure.
    Fig 2: Camshaft Position Sensor (Phase) Resistance Chart
    G02474030Courtesy of NISSAN MOTOR CO., U.S.A.
    Fig 3: Checking Camshaft Position Sensor (Phase) Resistance
    G02474031Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals