Base System: Notes
Refer to Owner's Manual for audio system operating instructions.
Power is supplied at all times
- Through 20A fuse [No. 31, located in the fuse and fusible link box]
- To audio unit terminal 6 and
- Through 10A fuse [No. 3, located in the fuse block (J/B)]
- To AV switch terminal 1 and
- To display unit terminal 1.
With the ignition switch in the ACC or ON position, power is supplied
- Through 10A fuse [No. 6, located in the fuse block (J/B)]
- To audio unit terminal 10 and
- To AV switch terminal 2 and
- To display unit terminal 2 and
- Through 10A fuse [No. 4, located in the fuse block (J/B)]
- To subwoofer amp. terminal 9.
With the ignition switch in the ON or START position, power is supplied
- Through 10A fuse [No. 12, located in the fuse block (J/B)]
- To display unit terminal 3.
Ground is supplied through the case of the audio unit.
Ground is also supplied
- To subwoofer amp. terminal 7
- Through body grounds B117 and B132.
Then audio signals are supplied
- Through audio unit terminals 1, 2, 3, 4, 13, 14, 15 and 16
- To terminals + and - of front door speaker LH and RH
- To terminals + and - of tweeter LH and RH.
- To terminals + and - of rear door speaker LH and RH
- To terminals 1, 2, 3 and 4 of subwoofer amp. and Through subwoofer amp. terminals 5, 6, 8 and 10
- To terminals + and - of subwoofer LH and RH.
When one of steering wheel audio control switches is pushed, the resistance in steering switch circuit changes depending on which button is pushed.