Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2005 >> Armada LE, 4WD >> Repair and Diagnosis >> Engine Performance >> Engine Control System >> DTC P0340: CMP Sensor (Phase) >> Component Inspection >> Camshaft Position Sensor (Phase)

Camshaft Position Sensor (Phase)

  1. Loosen the fixing bolt of the sensor.
  2. Disconnect camshaft position sensor (PHASE) harness connector.
  3. Remove the sensor.
  4. Visually check the sensor for chipping.
    Fig 1: Visually Checking Sensor For Chipping
    G02443675Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Check resistance as shown in the figure.
    Fig 2: Terminal Resistance Specification Chart
    G02443676Courtesy of NISSAN MOTOR CO., U.S.A.
    Fig 3: Checking Resistance
    G02443677Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals