Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2005 >> Altima SE-R, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 2 (Engine Control System - Qr25DE) >> DTC P1706: PNP Switch >> Overall Function Check >> With GST

With GST

WARNING: This page is about a different variant/trim than selected.
  1. Turn ignition switch ON.
  2. Check voltage between ECM terminal 102 (PNP switch signal) and ground under the following conditions.
    CONDITION AND VOLTAGE REFERENCE

    Condition (Gear position) Voltage V (Known good data)
    P or N position (A/T) Neutral position (M/T) Approx.
    Except the above position A/T: Battery voltage M/T: Approximately 5V
  3. If NG, go to "DIAGNOSTIC PROCEDURE ".
    Fig 1: Checking Voltage Between ECM Terminal 102 (PNP Switch Signal) And Ground
    G02526930Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals