Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2005 >> Altima SE-R, Automatic >> Repair and Diagnosis >> Brakes >> Traction Control >> Brake Control System >> Brake Control System - TCS/Abs >> Actuator And Electric Unit (Assembly) >> Removal and Installation >> Installation

Removal and Installation: Installation

CAUTION: After installation of ABS actuator and electric unit (control unit), refill brake fluid. Then bleed air from system. Refer to "BLEEDING BRAKE SYSTEM ".
  1. Position ABS actuator and electric unit (control unit) in vehicle.
  2. Install and tighten ABS actuator and electric unit (control unit) nuts and bolts.
  3. Install brake pipes to ABS actuator and electric unit (control unit), then tighten flare nuts. Refer to "HYDRAULIC CIRCUIT ".
  4. Connect ABS actuator and electric unit (control unit) harness connectors.
  5. Install windshield wiper and linkage assembly. Refer to "INSTALLATION ".
  6. Reconnect battery cable.
scientia non olet · About Mike's Workshop Manuals