Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2005 >> Altima Base >> Repair and Diagnosis >> Engine Performance >> Engine Control System - Qr25DE >> DTC P0453: EVAP Control System Pressure Sensor >> DIAGNOSTIC TROUBLE CODES Confirmation Procedure >> With Consult-II

With Consult-II

  1. Start engine and warm it up to normal operating temperature.
  2. Turn ignition switch OFF and wait at least 10 seconds.
  3. Turn ignition switch ON.
  4. Select "DATA MONITOR" mode with CONSULT-II.
  5. Make sure that "FUEL T/TMP SE" is more than 0°C (32°F).
  6. Wait at least 10 seconds.

    If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE "

    Fig 1: Display - DATA MONITOR Mode With CONSULT-II
    G02525154Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals