Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 533 (Engine Control System - Sedan) >> DTC P1706: PNP Switch >> DTC Confirmation Procedure >> With Consult-II

With Consult-II

WARNING: This page is about a different car, the 2005 Infiniti G35. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch ON.
  2. Select "P/N POSI SW" in "DATA MONITOR" mode with CONSULT-II. Then check the "P/N POSI SW" signal under the following conditions.
    CONDITION CHECK

    Position (Shift lever) Known-good signal
    N or P position (A/T) ON
    Neutral position (M/T) ON
    Except above position OFF
    Fig 1: Data Monitor Display
    G02349038Courtesy of NISSAN MOTOR CO., U.S.A.

    If NG, go to "Diagnostic Procedure ".

    If OK, go to following step.

  3. Select "DATA MONITOR" mode with CONSULT-II.
  4. Start engine and warm it up to normal operating temperature.
  5. Maintain the following conditions for at least 60 consecutive seconds.
    CONDITION MAINTAIN

    ENG SPEED 1,400 - 6375 RPM
    COOLAN TEMP/S More than 70°C (158°F)
    B/FUEL SCHDL 2.0 - 31.8 msec
    VHCL SPEED SE More than 64 km/h (40 MPH)
    Shift lever Suitable position
    Fig 2: DATA MONITOR Mode With CONSULT-II Display On Screen
    G02349039Courtesy of NISSAN MOTOR CO., U.S.A.
  6. If 1st trip DTC is detected, go to "Diagnostic Procedure "
scientia non olet · About Mike's Workshop Manuals