Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 44 (Engine Controls - System & Component Testing - 4 CYL & V6) >> Introduction

Section 44 (Engine Controls - System & Component Testing - 4 CYL & V6): Introduction

WARNING: This page does not describe the selected car, but rather 9 other vehicles, including the 2002 Nissan Xterra, 2002 Nissan Sentra, 2002 Nissan Quest, 2002 Nissan Pathfinder, and 2002 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Information for Sentra 1.8L, California Clean Air (CA) model is not available from manufacturer.

Before testing separate components or systems, perform procedures in BASIC DIAGNOSTIC PROCEDURES article. Since the introduction of OBD-II, most all computer-controlled and monitored components set a Diagnostic Trouble Code (DTC) if they malfunction. Information for these components is covered in appropriate SELF-DIAGNOSTICS article.

NOTE: Testing individual components does not isolate a short or open circuit. Perform all voltage tests using a Digital Volt-Ohmmeter (DVOM) with a minimum 10-megohm input impedance, unless stated otherwise in test procedure.