Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 432 (Automatic Transaxle - Re5F22A) >> DTC P0882 TCM Power Input Signal >> DTC Confirmation Procedure >> With Consult-II

With Consult-II

WARNING: This page is about a different car, the 2004 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch "ON". (Do not start engine.)
  2. Select "TRANSMISSION" with "DATA MONITOR" mode in Consult-II.
    Fig 1: Consult-II Display Screen
    G00777761Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Start engine.
  4. Depress accelerator pedal or drive vehicle and maintain the following condition for at least 20 consecutive seconds.

    TURBINE REV: More than 800 rpm 

  5. If DTC is detected, go to "Diagnostic Procedure ".
scientia non olet · About Mike's Workshop Manuals