Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 425 (Engine Control System - Introduction) >> Power Supply Circuit For ECM >> Diagnostic Procedure >> 9) Check ECM Power Supply Circuit-IV

9) Check ECM Power Supply Circuit-IV

WARNING: This page is about a different car, the 2004 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Check voltage between ECM terminal 111 and ground with CONSULT-II or tester.
    1. Voltage: Battery voltage 

OK or NG 

  1. OK: GO TO 10.
  2. NG: GO TO 12 .
Fig 1: Check ECM Power Supply Circuit-V
G00875841Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals