Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 425 (Engine Control System - Introduction) >> Power Supply Circuit For ECM >> Diagnostic Procedure >> 10) Check ECM Power Supply Circuit-V

10) Check ECM Power Supply Circuit-V

WARNING: This page is about a different car, the 2004 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect ECM harness connector.
  2. Disconnect IPDM E/R harness connector E122.
  3. Check harness continuity between ECM terminals 119, 120 and IPDM E/R terminal 18.

    Refer to Wiring Diagram.

    1. Continuity should exist. 
  4. Also check harness for short to ground and short to power.

OK or NG 

  1. OK: GO TO 15 .
  2. NG: GO TO 11.
scientia non olet · About Mike's Workshop Manuals