Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 423 (Engine Control System - DTC) >> DTC P1706: PNP Switch >> Procedure B >> 3. Check PNP Switch Power Supply Circuit

3. Check PNP Switch Power Supply Circuit

WARNING: This page is about a different car, the 2004 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch OFF.
  2. Disconnect PNP switch harness connector.
    Fig 1: Disconnect PNP Switch Harness Connector
    G00877688Courtesy of NISSAN MOTOR CO., U.S.A.
  3. Turn ignition switch ON.
  4. Check voltage between PNP switch terminal 3 and ground with CONSULT-II or tester.
    1. Voltage: Battery voltage 

OK or NG 

  1. OK: GO TO 5 .
  2. NG: GO TO 4.
Fig 2: Check voltage
G00877689Courtesy of NISSAN MOTOR CO., U.S.A.