Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 380 (Automatic Transmission) >> DTC Tests >> DTC P1710 A/T Fluid Temperature Sensor Circuit >> DTC Confirmation Procedure >> With CONSULT-II

With CONSULT-II

WARNING: This page is about a different car, the 2004 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch "ON". (Do not start engine.)
  2. Select "DATA MONITOR" mode for "ENGINE" with CONSULT-II.
  3. Start engine and maintain the following conditions for at least 10 minutes (Total). (It is not necessary to maintain continuously.)

    VHCL SPEED SE: 10 km/h (6 MPH) or more 

    THRTL POS SEN: More than 1.0/8 

    Selector lever: "D" position 

  4. If DTC is detected, go to DIAGNOSTIC PROCEDURE .
    Fig 1: CONSULT-II Display
    G00726652Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals