Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 2344 (Engine Control System - DTCS U1000 To P0153) >> DTC P0127 IAT Sensor >> DTC Confirmation Procedure >> With Consult-II

With Consult-II

WARNING: This page is about a different car, the 2007 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. Wait until engine coolant temperature is less than 90°C (194°F)
    1. Turn ignition switch ON.
    2. Select "DATA MONITOR" mode with CONSULT-II.
    3. Check the engine coolant temperature.
    4. If the engine coolant temperature is not less than 90°C (194°F), turn ignition switch OFF and cool down engine.
      • Perform the following steps before engine coolant temperature is above 90°C (194°F).
  2. Turn ignition switch ON.
  3. Select "DATA MONITOR" mode with CONSULT-II.
  4. Start engine.
  5. Hold vehicle speed at more than 70 km/h (43 MPH) for 100 consecutive seconds.
    Fig 1: CONSULT II Display - Data Monitor
    G04900237Courtesy of NISSAN NORTH AMERICA, INC.
  6. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
scientia non olet · About Mike's Workshop Manuals