Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 2344 (Engine Control System - DTCS U1000 To P0153) >> DTC P0101 MAF Sensor >> DTC Confirmation Procedure >> Procedure For Malfunction A >> With CONSULT-II

With CONSULT-II

WARNING: This page is about a different car, the 2007 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT-II.
  3. Start engine and warm it up to normal operating temperature.
  4. Run engine for at least 10 seconds at idle speed.
  5. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
    Fig 1: CONSULT-II Display - DATA MONITOR
    G04900167Courtesy of NISSAN NORTH AMERICA, INC.
scientia non olet · About Mike's Workshop Manuals