Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 2323 (Engine Control System - DTCS P1212 To P2A03) >> DTC P1805 Brake Switch >> Component Inspection >> Stop Lamp Switch

Stop Lamp Switch

WARNING: This page is about a different car, the 2006 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. Disconnect stop lamp switch harness connector.
    Fig 1: Identifying ASCD Brake Switch
    G04197049Courtesy of NISSAN MOTOR CO., U.S.A.
  2. Check continuity between stop lamp switch terminals 1 and 2 under the following conditions.
    STOP LAMP SWITCH CONTINUITY

    Conditions Continuity
    Brake pedal: Fully released Should not exist.
    Brake pedal: Slightly depressed Should exist.
  3. If NG, adjust stop lamp switch installation, refer to , "BRAKE PEDAL ", and perform step  2 again.
    Fig 2: Checking Continuity Between Stop Lamp Switch Terminals 1 And 2
    G04197050Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals