Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 2322 (Engine Control System - DTCS P0447 To P1211) >> DTC P0850 PNP Switch >> Overall Function Check >> With GST

With GST

WARNING: This page is about a different car, the 2006 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch ON.
  2. Check voltage between ECM terminal 102 (PNP switch signal) and ground under the following conditions.
    PNP SWITCH VOLTAGE

    Condition (Gear position) Voltage V (Known good data)
    P or N position Approx. 0
    Except the above position BATTERY VOLTAGE (11 - 14V)
  3. If NG, go to , "DIAGNOSTIC PROCEDURE ".
    Fig 1: Identifying Voltage Between ECM Terminal 102 (PNP Switch Signal) And Ground
    G04196980Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals