Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 2320 (Engine Control System - DTCS U1000 To P0153) >> DTC P0101 MAF Sensor >> DTC Confirmation Procedure >> Procedure For Malfunction B >> With CONSULT-II

With CONSULT-II

WARNING: This page is about a different car, the 2006 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch ON.
  2. Start engine and warm it up to normal operating temperature.

    If engine cannot be started, go to , " DIAGNOSTIC PROCEDURE  ". 

  3. Select "DATA MONITOR" mode with CONSULT-II.
  4. Check the voltage of "MAS A/F SE-B1" with "DATA MONITOR".
  5. Increases engine speed to about 4, 000 rpm.
  6. Monitor the linear voltage rise in response to engine speed increases.

    If NG, go to , "DIAGNOSTIC PROCEDURE ".

    If OK, go to following step.

    Fig 1: Identifying Engine Speed
    G04196541Courtesy of NISSAN MOTOR CO., U.S.A.
  7. Maintain the following conditions for at least 10 consecutive seconds.
    ENGINE SPEED SPECIFICATION

    ENG SPEED More than 2, 000 rpm
    THRTL SEN 1 More than 3V
    THRTL SEN 2 More than 3V
    Shift lever Suitable position
    Driving location Driving vehicle uphill (Increased engine load) will help maintain the driving conditions required for this test.
  8. If 1st trip DTC is detected, go to , "DIAGNOSTIC PROCEDURE ".
    Fig 2: Scan Tool Display - Data Monitor
    G04196542Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals