Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 2314 (Engine Control System - DTCS U1000 To P0153) >> DTC P0101 MAF Sensor >> DTC Confirmation Procedure >> Procedure For Malfunction A

Procedure For Malfunction A

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If engine will not start or stops soon, wait at least 10 seconds with engine stopped (Ignition switch ON) instead of running engine at idle speed.
  1. Start engine and warm it up to normal operating temperature.
  2. Run engine for at least 10 seconds at idle speed.
  3. Check 1st trip DTC.
  4. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE "
scientia non olet · About Mike's Workshop Manuals