Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 2286 (Engine Control System - DTCS P0444 Through P1168) >> DTC P0451 EVAP Control System Pressure Sensor >> DTC Confirmation Procedure >> With Consult-III

With Consult-III

WARNING: This page is about a different car, the 2008 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. If DTC Confirmation Procedure has been previously conducted, always perform the following before conducting the next step.
    1. Turn ignition switch OFF and wait at least 10 seconds.
    2. Turn ignition switch ON.
    3. Turn ignition switch OFF and wait at least 10 seconds.
  2. Start engine and wait at least 40 seconds.
    NOTE: Do not depress accelerator pedal even slightly.
  3. Check 1st trip DTC.
  4. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
scientia non olet · About Mike's Workshop Manuals