Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 2285 (Engine Control System - DTCS P0137 Through P0443) >> DTC P0403 EGR Volume Control Valve >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2008 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.
  1. Turn ignition switch OFF and wait at least 10 seconds.
  2. Turn ignition switch ON.
  3. Turn ignition switch OFF and wait at least 10 seconds.

TESTING CONDITION: 

Before performing the following procedure, confirm that battery voltage is more than 10V at idle. 

  1. Start engine and warm it up to normal operating temperature.
  2. Rev engine from idle to 2, 000 rpm for 10 times.
  3. Check DTC.
  4. If DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
scientia non olet · About Mike's Workshop Manuals