Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 2284 (Engine Control System - DTCS U1000 Through P0153) >> DTC P0125 ECT Sensor >> DTC Confirmation Procedure >> With Consult-III

With Consult-III

WARNING: This page is about a different car, the 2008 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT-III.
  3. Check that "COOLAN TEMP/S" is above 10°C (50°F).

    If it is above 10°C (50°F), the test result will be OK. 

    If it is below 10°C (50°F), go to following step. 

  4. Start engine and run it for 65 minutes at idle speed.

    If "COOLAN TEMP/S" increases to more than 10°C (50°F) within 65 minutes, stop engine because the test result will be OK. 

  5. Check 1st trip DTC.
  6. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
scientia non olet · About Mike's Workshop Manuals