Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 2259 (2004.5 - Engine Control System - Introduction - Sedan) >> Trouble Diagnosis >> ECM Terminals and Reference Value >> ECM Inspection Table

ECM Inspection Table

WARNING: This page is about a different car, the 2004 Infiniti G35. However, it is still accessible from the selected car via links, so may be relevant.

Specification data are reference values and are measured between each terminal and ground.

Pulse signal is measured by CONSULT-II.

CAUTION: Do not use ECM ground terminals when measuring input/output voltage. Doing so may result in damage to the ECMs transistor. Use a ground other than ECM terminals, such as the ground.
Fig 1: ECM Inspection Chart (1 Of 9)
G03324888Courtesy of NISSAN MOTOR CO., U.S.A.
Fig 2: ECM Inspection Chart (2 Of 9)
G03324889Courtesy of NISSAN MOTOR CO., U.S.A.
Fig 3: ECM Inspection Chart (3 Of 9)
G03324890Courtesy of NISSAN MOTOR CO., U.S.A.
Fig 4: ECM Inspection Chart (4 Of 9)
G03324891Courtesy of NISSAN MOTOR CO., U.S.A.
Fig 5: ECM Inspection Chart (5 Of 9)
G03324892Courtesy of NISSAN MOTOR CO., U.S.A.
Fig 6: ECM Inspection Chart (6 Of 9)
G03324893Courtesy of NISSAN MOTOR CO., U.S.A.
Fig 7: ECM Inspection Chart (7 Of 9)
G03324894Courtesy of NISSAN MOTOR CO., U.S.A.
Fig 8: ECM Inspection Chart (8 Of 9)
G03324895Courtesy of NISSAN MOTOR CO., U.S.A.
Fig 9: ECM Inspection Chart (9 Of 9)
G03324896Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals