Symptom Chart (With Rear Power Vent Windows)
WARNING: This page is about a different car, the 2008 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
- Check that other systems using the signal of the following systems operate normally.SYMPTOM CHART
Symptom Repair order None of the power windows can be operated using any switch 1. BCM POWER SUPPLY AND GROUND CIRCUIT CHECK 2. Main power window and door lock/unlock supply and ground circuit check. Refer to MAIN POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH POWER SUPPLY CIRCUIT CHECK (WITH REAR POWER VENT WINDOWS) . 3. Power window serial link check. Refer to POWER WINDOW SERIAL LINK CHECK FRONT LH AND RH (WITHOUT REAR POWER VENT WINDOWS) . Front power window LH alone does not operate 1. Front power window motor LH circuit check. Refer to FRONT POWER WINDOW MOTOR LH CIRCUIT CHECK 2. Replace main power window and door lock/unlock switch. Refer to DOOR FINISHER . Front power window RH alone does not operate 1. POWER WINDOW AND DOOR LOCK/UNLOCK SWITCH RH POWER AND GROUND CIRCUIT CHECK 2. Power window serial link check. Refer to POWER WINDOW SERIAL LINK CHECK FRONT LH AND RH (WITH REAR POWER VENT WINDOWS) . 3. Front power window motor RH circuit check. Refer to FRONT POWER WINDOW MOTOR RH CIRCUIT CHECK (WITHOUT REAR POWER VENT WINDOWS) . 4. Replace BCM. Refer to REMOVAL AND INSTALLATION OF BCM . Rear power vent window LH alone does not operate 1. REAR POWER VENT WINDOW MOTOR LH CIRCUIT CHECK Rear power vent window RH alone does not operate 1. REAR POWER VENT WINDOW MOTOR RH CIRCUIT CHECK Anti-pinch system does not operate normally (front LH) 1. Door window sliding part malfunction - A foreign material adheres to window glass or glass run rubber.
- Glass run rubber wear or deformation.
- Sash is tilted too much, or not enough.
2. Limit Switch Adjusting. Refer to SETTING OF LIMIT SWITCH 3. Limit switch circuit check LH. Refer to LIMIT SWITCH CIRCUIT CHECK FRONT LH (WITH REAR POWER VENT WINDOWS) . 4. Encoder circuit check LH. Refer to ENCODER CIRCUIT CHECK FRONT LH (WITHOUT REAR POWER VENT WINDOWS) Anti-pinch system does not operate normally (front RH) 1. Door window sliding part malfunction - A foreign material adheres to window glass or glass run rubber.
- Glass run rubber wear or deformation.
- Sash is tilted too much, or not enough.
2. Limit Switch Adjusting. Refer to SETTING OF LIMIT SWITCH 3. Limit switch circuit check RH. Refer to LIMIT SWITCH CIRCUIT CHECK FRONT RH . 4. Encoder circuit check RH. Refer to ENCODER CIRCUIT CHECK FRONT RH (WITH REAR POWER VENT WINDOWS) . Power window retained power operation does not operate properly 1. Check the retained power operation mode setting. Refer to WORK FLOW . 2. DOOR SWITCH CHECK 3. Replace BCM. Refer to REMOVAL AND INSTALLATION OF BCM . Front power windows do not operate by front door lock assembly LH (key cylinder switch) 1. FRONT DOOR LOCK ASSEMBLY LH (KEY CYLINDER SWITCH) CHECK 2. Replace main power window and door lock/unlock switch. Refer to DOOR FINISHER . Power window lock switch does not function 1. Power window lock switch circuit check. Refer to POWER WINDOW SERIAL LINK CHECK FRONT LH AND RH (WITH REAR POWER VENT WINDOWS) .