Runout Inspection
WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
- Using wheel nuts, fix disc rotor to the wheel hub in 2 or more positions.
- Inspect runout using a dial gauge.
Measurement position: At a point 10 mm (0.39 in) from outer edge of the disc
Runout limit (with it attached to the vehicle): 0.07 mm (0.0028 in) or less
CAUTION: Before measuring, make sure the axle endplay is within specification. Refer to "FRONT WHEEL BEARING ". - If runout is outside the limit, find the minimum runout point by shifting mounting positions of the disc rotor and wheel hub by one hole.