Disassembly and Assembly: Assembly

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

Install the inner tie-rod sockets.
Install the outer tie-rod sockets to the specified length L and tighten the outer tie-rod socket lock nut to specification.
NOTE: Use Genuine High Temperature, High Strength Thread Locking Sealant (Red) or equivalent. Refer to "RECOMMENDED CHEMICAL PRODUCTS AND SEALANTS ".

Fig 1: Adjusting Inner Socket To Standard Length L
Courtesy of NISSAN MOTOR CO., U.S.A.
Measure rack stroke. Refer to "STEERING GEAR AND LINKAGE ".

Fig 2: Identifying Rack Stroke
Courtesy of NISSAN MOTOR CO., U.S.A.
Before installing boot, coat the contact surfaces between boot and tie-rod socket with grease.

Fig 3: Coating Contact Surfaces Between Boot And Tie-Rod Socket With Grease
Courtesy of NISSAN MOTOR CO., U.S.A.
Install the large boot clamp and crimp securely using Tool, then install the small boot clamp.
Tool number: KV40107300 ( - )

Fig 4: Identifying Large And Small Boot Clamps
Courtesy of NISSAN MOTOR CO., U.S.A.