Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 2069 (Driver Information System) >> Combination Meters >> Self-Diagnosis Mode of Combination Meter >> Operation Procedure

Operation Procedure

WARNING: This page is about a different car, the 2008 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch ON, and switch the odo/trip meter to "trip A" or "trip B".
    NOTE: If the diagnosis function is activated with trip meter A displayed, the mileage on trip meter A will indicate 0000.0 miles, but the actual trip mileage will be retained. (Trip B operates the same way.)
  2. Turn ignition switch OFF.
  3. While pushing the odo/trip meter switch (1), turn ignition switch ON again.
    Fig 1: Identifying Odo/Trip Meter Switch
    G04917981Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Make sure the trip meter displays "0000.0".
  5. Push the odo/trip meter switch (1) at least 3 times within 5 seconds.
  6. All the segments on the odo/trip meter and CVT indicator illuminate, and simultaneously the low-fuel warning lamp indicator illuminates. At this time, the unified meter control unit is turned to diagnosis mode.
    NOTE: If any of the segments are not displayed, replace the combination meter.
    Fig 2: Low-Fuel Warning Lamp Indicator Screen Display
    G04917982Courtesy of NISSAN MOTOR CO., U.S.A.
  7. Push the odo/trip meter switch. Each meter/gauge should indicate as shown in the figure while pushing odo/trip meter switch. (At this time, the low-fuel warning lamp goes off.)
    Fig 3: Identifying Odo/Trip Meter Switch
    G04917983Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals