Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 2059 (Audio, Visual, Navigation & Telephone System) >> Integrated Display System >> Ignition Signal Check (With Monochrome Display)

Ignition Signal Check (With Monochrome Display)

WARNING: This page is about a different car, the 2007 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK IGNITION SIGNAL 
    1. Disconnect the display unit connector.
    2. Turn ignition switch ON.
    3. Check voltage between display unit harness connector M93 terminal 3 and ground.

      Battery voltage should exist. 

    OK or NG 

    OK: Replace display unit. Refer to "DISPLAY UNIT ".

    NG: Check harness for open or short between display unit and fuse.

    Fig 1: Checking Voltage Between Display Unit Connector M93 Terminal 3 And Ground
    G04909215
scientia non olet · About Mike's Workshop Manuals