CONSULT-II Function (TRANSMISSION): Notes
WARNING: This page is about a different car, the 2007 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.
CONSULT-II can display each diagnostic item using the diagnostic test modes shown following.
A/T DIAGNOSTIC MODE DESCRIPTION CHART
| A/T diagnostic mode | Description |
|---|---|
| WORK SUPPORT | Supports inspections and adjustments. Commands are transmitted to the TCM for setting the status suitable for required operation, input/output signals are received from the TCM and received data is displayed. |
| SELF-DIAG RESULTS | Displays TCM self-diagnosis results. |
| DATA MONITOR | Displays TCM input/output data in real time. |
| CAN DIAG SUPPORT MNTR | The result of transmit/receive diagnosis of CAN communication can be read. |
| ACTIVE TEST | Operation of electrical loads can be checked by sending drive signal to them. |
| FUNCTION TEST | Conducted by CONSULT-II instead of a technician to determine whether each system is "OK" or "NG". |
| ECU PART NUMBER | TCM part number can be read. |