Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 1932 (Brakes - Abs) >> Anti-Lock Brake System >> Data List / Active Test

Data List / Active Test

WARNING: This page is about a different car, the 2006 Scion tC. However, it is still accessible from the selected car via links, so may be relevant.
  1. READ DATA LIST 

    HINT:

    According to the DATA LIST displayed on the intelligent tester, you can read the value and status of the switch, sensor, actuator and so on without parts removal. Reading the DATA LIST as the first stop of troubleshooting is one of the methods to shorten labor time.

    1. Connect the intelligent tester to the DLC3.
    2. Turn the ignition switch to the ON position.
    3. From the display on the tester, read the DATA LIST.
    DATA LIST

    Item Measurement Item / Range (Display) Normal Condition Diagnostic Note
    AIR BLD SUPPORT Air bleed support / SUPPORT or NOT SUP Support / Not support -
    PKB SW Parking brake switch / ON or OFF ON: Parking brake applied
    OFF: Parking brake released
    -
    STOP LIGHT SW Stop light switch / ON or OFF ON: Brake pedal depressed
    OFF: Brake pedal released
    -
    ABS MOT RELAY ABS motor relay / ON or OFF ON: Motor relay ON
    OFF: Motor relay OFF
    -
    SOL RELAY Solenoid relay / ON or OFF ON: Solenoid relay ON
    OFF: Solenoid relay OFF
    -
    TEST MODE Test mode operation / NORMAL or TEST NORMAL: Normal mode
    TEST: During test mode
    -
    ABS OPERT RL ABS operation (RL) / BEFORE or OPERATE BEFORE: No ABS operation (RL)
    OPERATE: During ABS operation (RL)
    Similar speed as indicated on speedometer
    ABS OPERT RR ABS operation (RR) / BEFORE or OPERATE BEFORE: No ABS operation (RR)
    OPERATE: During ABS operation (RR)
    Similar speed as indicated on speedometer
    ABS OPERT FL ABS operation (FL) / BEFORE or OPERATE BEFORE: No ABS operation (FL)
    OPERATE: During ABS operation (FL)
    -
    ABS OPERT FR ABS operation (FR) / BEFORE or OPERATE BEFORE: No ABS operation (FR)
    OPERATE: During ABS operation (FR)
    -
    SRLR ABS solenoid (SRLR) ON / OFF ON: Operated
    OFF: Not operated
    -
    SRLH ABS solenoid (SRLH) ON / OFF ON: Operated
    OFF: Not operated
    -
    SRRR (SRR) ABS solenoid (SRRR (SRR)) ON / OFF ON: Operated
    OFF: Not operated
    -
    SRRH (SRH) ABS solenoid (SRRH (SRH)) ON / OFF ON: Operated
    OFF: Not operated
    -
    SFLR ABS solenoid (SFLR) ON / OFF ON: Operated
    OFF: Not operated
    -
    SFLH ABS solenoid (SFLH) ON / OFF ON: Operated
    OFF: Not operated
    -
    SFRR ABS solenoid (SFRR) ON / OFF ON: Operated
    OFF: Not operated
    -
    SFRH ABS solenoid (SFRH) ON / OFF ON: Operated
    OFF: Not operated
    -
    WHEEL SPD FR Wheel speed sensor (FR) reading / min.: 0 km/h (0 mph), max.: 326 km/h (202 mph) Actual wheel speed Similar speed as indicated on speedometer
    WHEEL SPD FL Wheel speed sensor (FL) reading / min.: 0 km/h (0 mph), max.: 326 km/h (202 mph) Actual wheel speed Similar speed as indicated on speedometer
    WHEEL SPD RR Wheel speed sensor (RR) reading / min.: 0 km/h (0 mph), max.: 326 km/h (202 mph) Actual wheel speed Similar speed as indicated on speedometer
    WHEEL SPD RL Wheel speed sensor (RL) reading / min.: 0 km/h (0 mph), max.: 326 km/h (202 mph) Actual wheel speed Similar speed as indicated on speedometer
    VEHICLE SPD Vehicle speed / min.: 0 km/h (0 mph), max.: 326 km/h (202 mph) Actual wheel speed Similar speed as indicated on speedometer
    IG VOLTAGE ECU power supply voltage / TOO HIGH / NORMAL / TOO LOW TOO HIGH: 14 V or over
    NORMAL: 9.8 V to 14 V
    TOO LOW: Below 9.8 V
    -
    SPD SEN FR FR speed sensor open detection / OPEN or NORMAL OPEN: Momentary interruption -
    SPD SEN FL FL speed sensor open detection / OPEN or NORMAL OPEN: Momentary interruption -
    SPD SEN RR RR speed sensor open detection / OPEN or NORMAL OPEN: Momentary interruption -
    SPD SEN RL RL speed sensor open detection / OPEN or NORMAL OPEN: Momentary interruption -
  2. PERFORM ACTIVE TEST 

    HINT:

    Performing the ACTIVE TEST using the intelligent tester allows the relay, actuator and so on to operate without parts removal. Performing the ACTIVE TEST as the first step of troubleshooting is one of the methods to shorten labor time.

    It is possible to display the DATA LIST during the ACTIVE TEST.

    1. Connect the intelligent tester to the DLC3.
    2. Turn the ignition switch to the ON position.
    3. According to the display on the tester, perform the ACTIVE TEST.

      HINT:

      Ignition switch must be turned to the ON position to proceed to the ACTIVE TEST using the intelligent tester.

    ACTIVE TEST

    Item Vehicle Condition / Test Details Diagnostic Note
    ABS MOT RELAY Turns ABS motor relay ON / OFF Operation of solenoid (clicking sound) can be heard
    SOL RELAY Turns solenoid relay ON / OFF Operation of solenoid (clicking sound) can be heard
    BRAKE WRN LIGHT Turns BRAKE warning light ON / OFF Observe combination meter
    ABS WARN LIGHT Turns ABS warning light ON / OFF Observe combination meter
    SRLR Turns ABS solenoid (SRLR) ON / OFF Operation of solenoid (clicking sound) can be heard
    SRLH Turns ABS solenoid (SRLH) ON / OFF Operation of solenoid (clicking sound) can be heard
    SRRR Turns ABS solenoid (SRRR) ON / OFF Operation of solenoid (clicking sound) can be heard
    SRRH Turns ABS solenoid (SRRH) ON / OFF Operation of solenoid (clicking sound) can be heard
    SFLR Turns ABS solenoid (SFLR) ON / OFF Operation of solenoid (clicking sound) can be heard
    SFLH Turns ABS solenoid (SFLH) ON / OFF Operation of solenoid (clicking sound) can be heard
    SFRR Turns ABS solenoid (SFRR) ON / OFF Operation of solenoid (clicking sound) can be heard
    SFRH Turns ABS solenoid (SFRH) ON / OFF Operation of solenoid (clicking sound) can be heard
    SFRR & SFRH Turns ABS solenoid SFRR & SFRH ON / OFF Operation of solenoid (clicking sound) can be heard
    SFLR & SFLH Turns ABS solenoid SFLR & SFLH ON / OFF Operation of solenoid (clicking sound) can be heard
    SRH & SRR Turns ABS solenoid SRRR & SRRH ON / OFF Operation of solenoid (clicking sound) can be heard
    SRLR & SRLH Turns ABS solenoid SFRR & SFRH ON / OFF Operation of solenoid (clicking sound) can be heard
    SFRH & SFLH Turns ABS solenoid SFRR & SFRH ON / OFF Operation of solenoid (clicking sound) can be heard