Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 1799 (Body, Lock & Security System) >> NVIS(NISSAN Vehicle Immobilizer System-NATS) >> ECM Re-communicating Function

ECM Re-communicating Function

WARNING: This page is about a different car, the 2006 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

The following procedure can automatically perform re-communication of ECM and BCM, but only when the ECM has been replaced with a new one which has never been energized on-board.

(In this step, initialization procedure by CONSULT-II is not necessary).

NOTE:
  • When registering new Key IDs or replacing the ECM other than brand new.
  • If multiple keys are attached to the key holder, separate them before work.
  • Distinguish keys with unregistered key ID from those with registered ID.
  1. Install ECM.
  2. Using a registered key (*1), turn ignition switch to ON.

    *1: To perform this step, use the key that has been used before performing ECM replacement.

  3. Maintain ignition switch in ON position for at least 5 seconds.
  4. Turn ignition switch to OFF.
  5. Start engine.

    If engine can be started, procedure is completed.

    If engine cannot be started, refer to CONSULT-II Operation Manual NATS-IVIS/NVIS and initialize control unit.

scientia non olet · About Mike's Workshop Manuals