Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 1723 (Brake Control System (Coupe)) >> VDC/TCS/APS >> Trouble Diagnosis For System >> CAN Communication Circuit >> Inspection Procedure

Inspection Procedure

WARNING: This page is about a different car, the 2006 Infiniti G35. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK CONNECTOR 
    1. Turn ignition switch OFF and disconnect VDC/TCS/ABS control unit connector and steering angle sensor connector. Check terminal for deformation, disconnection, looseness, and so on. If any malfunction is found, repair or replace terminal.
    2. Securely reconnect connectors and perform self-diagnosis.
      SELF-DIAGNOSIS RESULTS TABLE

      Self-diagnostic results
      CAN COMM CIRCUIT
      ST ANG SEN COM CIR

    Is above displayed in the self-diagnosis item? 

    YES: Print out self-diagnostic results and go to "Precautions When Using CONSULT-II ".

    NO: Connector terminal connection is loose, damaged, open or shorted.

scientia non olet · About Mike's Workshop Manuals