Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 1555 (Body, Lock & Security System) >> Hood >> Removal And Installation Of Hood Lock Control >> Installation

Removal And Installation Of Hood Lock Control: Installation

WARNING: This page is about a different car, the 2005 Nissan Titan. However, it is still accessible from the selected car via links, so may be relevant.
  1. Pull the hood lock cable through the panel hole to the engine room.

    Be careful not to bend the cable too much, keeping the radius 100 mm (3.94 in) or more.

  2. Make sure the cable is not offset from the positioning grommet, and push the grommet into the panel hole securely.
  3. Apply the sealant to the grommet (at * mark) properly.
    Fig 1: Applying Sealant To Grommet
    G00341603Courtesy of NISSAN MOTOR CO., U.S.A.
  4. Install the cable securely to the lock.
  5. After installing, check the hood lock adjustment and hood opener operation.
    Fig 2: Installing Cable To Lock
    G00341604Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals