Consult-II Inspection Procedure

WARNING: This page is about a different car, the 2005 Nissan Quest. However, it is still accessible from the selected car via links, so may be relevant.

CAUTION: If CONSULT-II is used with no connection of CONSULT-II CONVERTER, malfunctions might be detected in self-diagnosis depending on control unit which carry out CAN communication.

Turn ignition switch OFF.
Connect CONSULT-II and CONSULT-II CONVERTER to the data link connector.

Fig 1: Identifying Data Link Connector Location
Courtesy of NISSAN MOTOR CO., U.S.A.
Turn ignition switch ON.
Touch "START (NISSAN BASED VHCL)".

Fig 2: CONSULT-II Data Display START (NISSAN BASED VHCL)
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "BCM".
If "BCM" is not indicated, refer to "CONSULT-II DATA LINK CONNECTOR (DLC) CIRCUIT ".

Fig 3: CONSULT-II Data Display BCM
Courtesy of NISSAN MOTOR CO., U.S.A.
Touch "THEFT ALM" on the "SELECT TEST ITEM" screen.

Fig 4: CONSULT-II Data Display SELECT TEST ITEM
Courtesy of NISSAN MOTOR CO., U.S.A.
Select diagnosis mode.
"DATA MONITOR""ACTIVE TEST" and "WORK SUPPORT" are available.

Fig 5: CONSULT-II Data Display ACTIVE TEST And WORK SUPPORT
Courtesy of NISSAN MOTOR CO., U.S.A.