With Consult-II

WARNING: This page is about a different car, the 2005 Nissan 350Z. However, it is still accessible from the selected car via links, so may be relevant.

Turn ignition switch ON and select "DATA MONITOR" mode with CONSULT-II.
Start engine and warm it up to the normal operating temperature.

Maintain the following conditions for at least 6 consecutive seconds.

Hold the accelerator pedal as steady as possible.

Fig 1: Scan Tool Display "Data Monitor"

Courtesy of NISSAN MOTOR CO., U.S.A.

FAIL-SAFE MODE CHART

VHCL SPEED SE	100 - 120 km/h (63 - 75 MPH)
ENG SPEED	2, 000 - 4, 000 rpm (A constant rotation is maintained.)
COOLANT TEMPS	60 - 120°C (140 - 248°F)
B/FUELSCHDL	More than 7.26 msec
Shift lever	D position (A/T)
Shift lever	5th position (M/T)

Let engine idle for 10 seconds.
If the 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
If the 1st trip DTC is not detected, go to next step.

Maintain the following conditions for at least 20 consecutive seconds

DTC CHART

ENG SPEED	1, 700 - 3, 175 rpm (A constant rotation is maintained.)
COOLANT TEMPS	70 - 105°C (158 - 221°F)

SHIFT LEVER REFERENCE

Shift lever	1st or 2nd position
Driving location uphill	Driving vehicle uphill (Increased engine load will help maintain the driving conditions required for this test.)

If the 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE "