Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 1112 (Continuously Variable Transmission (CVT)) >> DTC P1745 Line Pressure Control >> DTC Confirmation Procedure >> With Consult-II

With Consult-II

WARNING: This page is about a different car, the 2004 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch ON and select "DATA MONITOR" mode for "TRANSMISSION" with CONSULT-II.
  2. Make sure that output voltage of CVT fluid temperature sensor is within the range below.

    FLUID TEMP SEN: 1.0 - 2.0V 

    If out of range, drive the vehicle to decrease the voltage (warm up the fluid) or stop engine to increase the voltage (cool down the fluid) 

  3. If DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
    Fig 1: DATA MONITOR - Consult II Display
    G00769784Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals