Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 1112 (Continuously Variable Transmission (CVT)) >> DTC P0715 Input Speed Sensor Circuit (PRI Speed Sensor) >> DTC Confirmation Procedure >> With Consult-II

With Consult-II

WARNING: This page is about a different car, the 2004 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
  1. Turn ignition switch ON and select "DATA MONITOR" mode for "ENGINE" with CONSULT-II.
  2. Start engine and maintain the following conditions for at least 5 consecutive seconds.

    VHCL SPEED SE: 10 km/h (6 MPH) or more 

    ACC PEDAL OPEN: More than 1/8 

    Selector lever: D position 

    ENG SPEED: 450 RPM or more 

    Driving location: Driving the vehicle uphill (increased engine load) will help maintain the driving conditions required for this test. 

  3. If DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
scientia non olet · About Mike's Workshop Manuals