Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2004 >> Sentra SE-R >> Repair and Diagnosis >> External Pages >> Different car >> Section 106 (Engine Controls - Self-Diagnostics) >> Diagnostic Tests >> DTC P1706: Park/Neutral Position Switch >> DTC Confirmation Test (Using Generic Scan Tool)

DTC Confirmation Test (Using Generic Scan Tool)

WARNING: This page is about a different car, the 2003 Infiniti Q45. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Use the following test to check overall function of PNP switch circuit. During this test, 1st trip DTC may not be confirmed.
CAUTION: DO NOT use ECM ground terminals when measuring voltage.

To check overall function of PNP switch circuit, turn ignition on. Measure voltage between body ground and PNP switch signal circuit at ECM terminal No. 80 (Gray/Red wire) by backprobing. See Figure and Figure . With transmission in Park or Neutral, voltage should be about zero volts. With transmission in any other position, battery voltage should exist. If voltage is as specified, system is okay at this time. If voltage is not as specified, go to DIAGNOSTIC PROCEDURE  .

scientia non olet · About Mike's Workshop Manuals