Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2004 >> Sentra Base, Standard >> Repair and Diagnosis >> Engine Performance >> System >> Engine Control System - QG18DE >> DTC P0340: CMP Sensor (Phase) >> Component Inspection >> Camshaft Position Sensor (Phase)

Camshaft Position Sensor (Phase)

  1. Loosen the fixing bolt of the sensor.
  2. Disconnect camshaft position sensor (PHASE) harness connector.
  3. Remove the sensor.
  4. Visually check the sensor for chipping.
    Fig 1: Identifying Camshaft Position Sensor (Phase)
    G00772820Courtesy of NISSAN MOTOR CO., U.S.A.
  5. Check resistance as shown in the figure.
    Fig 2: Terminal Resistance Chart
    G00772821Courtesy of NISSAN MOTOR CO., U.S.A.
Fig 3: Checking Resistance
G00772822Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals