Procedure For Malfunction A And B

With CONSULT-II 

1. Turn ignition witch ON and wait at least 1 second.
2. Select "DATA MONITOR" mode with CONSULT-II.
3. Shift selector lever to D position, and wait at least 2 seconds.
4. Shift selector lever to P position.
5. Turn ignition witch OFF and wait at least 10 second.
6. Turn ignition witch ON and wait at least 1 second.
7. Shift selector lever to D position, and wait at least 2 seconds.
8. Shift selector lever to P position.
9. Turn ignition switch OFF, wait at least 10 seconds, and then turn ON.
10. If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE  .
    Fig 1: Display Data Monitor Screen

    Courtesy of NISSAN MOTOR CO., U.S.A.

With GST 

Follow the procedure "With CONSULT-II" above.