With CONSULT-II
- Turn ignition switch OFF and wait at a least 10 seconds.
- Start engine and warm it up to normal operating temperature.
- Drive the vehicle at a speed of 80 km/h (50 MPH) for a few minutes in D position with "OD" OFF (A/T models) or 5th position (M/T models).NOTE: Keep the accelerator pedal as steady as possible during the cruising.
- Set "OD" ON, then release the accelerator pedal fully until the vehicle speed decreases to 50 km/h (30 MPH).NOTE: Never apply brake during releasing the accelerator pedal.
- Repeat steps 3 to 4 five times.
- Stop the vehicle and connect CONSULT-II to the vehicle.
- Make sure that no (1st trip) DTC is displayed in "SELF-DIAG RESULTS" mode.
OK or NG