6. Check Cooling Fan Motor-1 Circuit-II

1. Turn ignition switch OFF.
2. Disconnect IPDM E/R harness connector E118.
3. Check harness continuity between the following terminals.

   Cooling fan motor-1 terminal 3 and IPDM E/R terminal 8

   Cooling fan motor-1 terminal 4 and IPDM E/R terminals 11, 12 Refer to Wiring diagram.

   1. Continuity should exist. 
4. Also check harness for short to ground or short to power.

OK or NG 

1. OK: GO TO 7.
2. NG: Repair open circuit or short to ground or short to power in harness or connectors.