Testing Condition:

WARNING: This page is about a different variant/trim than selected.

For best results, perform at ambient temperature of - 10°C (14°F) or higher.
For best results, perform at engine coolant temperature of - 10°C (14°F) to 70°C (158°F).

WITH CONSULT-II

Replace thermostat with new one. Refer to "THERMOSTAT ". Use only a genuine NISSAN thermostat as a replacement. If an incorrect thermostat is used, the MIL may come on.
Turn ignition switch ON.
Select "COOLAN TEMP/S" in "DATA MONITOR" mode with CONSULT-II.
Check that the "COOLAN TEMP/S" is above 70°C (158°F).
If it is below 70°C (158°F), go to following step.

If it is above 70°C (158°F), stop engine and cool down the engine to less than 70°C (158°F), then retry from step 1.
Drive vehicle for 10 consecutive minutes under the following conditions.

Fig 1: Vehicle Speed Specification
Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 2: Displaying "DATA MONITOR" Mode
Courtesy of NISSAN MOTOR CO., U.S.A.

If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".

WITH GST

Follow the procedure "WITH CONSULT-II" above.