Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2004 >> Frontier Base, Standard >> Repair and Diagnosis >> External Pages >> Different variant/trim >> Section 3 (Engine Control System - VG33E) >> DTC P0340: CMP Sensor >> DTC Confirmation Procedure >> Procedure For Malfunction B And C

Procedure For Malfunction B And C

WARNING: This page is about a different variant/trim than selected.

With CONSULT-II 

  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT-II.
  3. Start engine and run it for at least 2 seconds at idle speed.
  4. If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
Fig 1: Reading "MONITOR" In "DATA MONITOR" Mode
G00741834Courtesy of NISSAN MOTOR CO., U.S.A.

With GST 

Follow the procedure "With CONSULT-II".

scientia non olet · About Mike's Workshop Manuals