Procedure For Malfunction A

WARNING: This page is about a different variant/trim than selected.

With CONSULT-II

Turn ignition switch ON.
Select "DATA MONITOR" mode with CONSULT-II.
Start engine and let it idle for at least 10 seconds.
If idle speed is over 1, 000 RPM, maintain the following conditions for at least 10 seconds to keep engine speed below 1, 000 RPM.

Fig 1: Conditions Chart
Courtesy of NISSAN MOTOR CO., U.S.A.

Fig 2: Reading "ENG SPEED" In "Data Monitor" Mode
Courtesy of NISSAN MOTOR CO., U.S.A.
If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".

With GST

Follow the procedure "With CONSULT-II".