Procedure For DTC P0103

WARNING: This page is about a different variant/trim than selected.

With CONSULT-II

Turn ignition switch ON.
If 1st trip DTC is detected,
Select "DATA MONITOR" mode with CONSULT-II.
Wait at least 6 seconds.
If 1st trip DTC is detected, go to "DIAGNOSTIC PROCEDURE ".
If 1st trip DTC is not detected, go to next step.
Start engine and let it idle for at least 6 seconds.
If 1st trip DTC is detected, go to DIAGNOSTIC PROCEDURE ".

Fig 1: Reading "ENG SPEED" In "Data Monitor" Mode
Courtesy of NISSAN MOTOR CO., U.S.A.

With GST

Follow the procedure "With CONSULT-II".