Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Nissan-Datsun >> 2003 >> Sentra SE-R, Standard >> Repair and Diagnosis >> External Pages >> Different car >> Section 998 (Power Window System) >> Power Window System >> Front Power Window Switch (Passenger Side) Power Supply and Ground Circuit Check

Front Power Window Switch (Passenger Side) Power Supply and Ground Circuit Check

WARNING: This page is about a different car, the 2003 Nissan Murano. However, it is still accessible from the selected car via links, so may be relevant.
  1. CHECK POWER SUPPLY CIRCUIT 
    1. Turn ignition switch ON.
    2. Check voltage between front power window switch (passenger side) connector D35 terminal 10 and ground.
      1. 10 (W/R) - Ground : Battery voltage 

    OK or NG

    1. OK : Front power window switch (passenger side) power supply and ground circuit is OK.
    2. NG : GO TO 2.
    Fig 1: Checking Voltage Between Front Power Window Switch (Passenger Side) Connector D35 Terminal 10 And Ground
    G03358868Courtesy of NISSAN MOTOR CO., U.S.A.
  2. CHECK GROUND CIRCUIT 
    1. Turn ignition switch OFF.
    2. Disconnect front power window switch (passenger side) connector.
    3. Check continuity between front power window switch (passenger side) connector D35 terminal 11 and ground.
      1. 11 (B) - Ground : Continuity should exist. 

    OK or NG

    1. OK : GO TO 3.
    2. NG : Repair or replace harness.
    Fig 2: Checking Continuity Between Front Power Window Switch (Passenger Side) Connector D35 Terminal 11 And Ground
    G03358869Courtesy of NISSAN MOTOR CO., U.S.A.
  3. CHECK HARNESS CONTINUITY 
    1. Disconnect BCM connector.
    2. Check continuity between BCM connector M35 terminal 28 and front power window switch (passenger side) connector D35 terminal 10.
      1. 28 (W/R) - 10 (W/R) : Continuity should exist. 

    OK or NG

    1. OK : GO TO 4.
    2. NG : Repair or replace harness between BCM and front power window switch (passenger side).
    Fig 3: Checking Continuity Between BCM Connector M35 Terminal 28 And Front Power Window Switch (Passenger Side) Connector D35 Terminal 10
    G03358870Courtesy of NISSAN MOTOR CO., U.S.A.
  4. CHECK BCM OUTPUT SIGNAL 
    1. Connect BCM connector.
    2. Turn ignition switch ON.
    3. Check voltage between BCM connector M35 terminal 28 and ground.
      1. 28 (W/R) - Ground : Battery voltage 

    OK or NG

    1. OK : Check the condition of the harness and the connector.
    2. NG : Replace BCM.
    Fig 4: Checking Voltage Between BCM Connector M35 Terminal 28 And Ground
    G03358871Courtesy of NISSAN MOTOR CO., U.S.A.
scientia non olet · About Mike's Workshop Manuals